Fujitsu M2635S/M2636S/M2637S:Switch Settings

PCA Layout  All configurations marked * are default settings.

Set SCSI ID
  JMP7     JMP6     JMP5     ID
   OPEN      OPEN      OPEN       0
   OPEN      OPEN      SHORT      1
   OPEN      SHORT     OPEN       2
   OPEN      SHORT     SHORT      3
   SHORT     OPEN      OPEN       4
   SHORT     OPEN      SHORT      5
   SHORT     SHORT     OPEN       6
   SHORT*    SHORT*    SHORT*     7

The drive is shipped from the factory with the SCSI ID set to 7. This provides
the drive with enough shorting straps for any ID. It must be remembered
though that the host adapter normally takes ID 7 with all peripheral devices
using IDs 0 through to 6.

   JMP4   SHORT*   Spin up at power on
          OPEN     Spin via START/STOP UNIT command
   JMP3   SHORT*   SCSI parity enabled
          OPEN     SCSI parity disabled
   JMP2   SHORT*   UNIT ATTENTION enabled
          OPEN     UNIT ATTENTION disabled
   JMP1   SHORT*   SCSI level:Common Command Set
          OPEN     SCSI level:SCSI-2

to the table of contents!!